|
|
KC Cameron Inner circle Raleigh, North Carolina 1944 Posts |
I know most children's performers have Suit-Tables, and the Lefler seems to be the most popular. I am interested in the Clark model, on how it stands up to a children's magician's demands. -- Especially how tough it is. Can it take being tossed in and out of a car's trunk many times each week, if a child leans on it will it collapse?
I personally have never seen this table, and was hoping to get some reviews of it, especially some by people who own both the Lefler and the Clark tables. The Lefler table is sturdy, I have been banging mine around for 8 years or so, but it is also heavy, and apparently a bit smaller than the Clark table. I really value every square inch of space, and I like the lightness of the Clark table, I am just not sure how tough it is. http://www.tonyclarkmagic.com/storefront......vstart=0 http://www.wearefun.com/catalog/product_......s_id=353 |
wizardofsorts Special user Chicago, IL 935 Posts |
I do not own Tony's table but I would defiantly cover it with something. I don't really go for that plastic look. Even if it was just two signs, one on the upper portion and one below. I really don't like that the handle is in the middle of the top shelf. That is prime real estate. It would really seem like it would be right in the way. If he had the sort of handle like Lefler that had a lower profile I think it would be better. That is of course if you could reach the lower profile handle through the top layer when the case was closed in order to carry it.
Edd
Edd Fairman, Wizard of Sorts is a corporate magician available for your next trade show, hospitality suite, client luncheon, or company event. http://www.wizardofsorts.com
|
TrickyRicky Inner circle TrickyRicky 1653 Posts |
Hi CaptainKid.
I used a lefler rolon for 5 years and found it to be quite heavy to carry up and down stair. Yes, it is quite sturdy and can take quite a beating. At present I'm using the older Tony Clark's rolon, made from wood. It's much lighter than the Lefler model. I have Tony's new model on order. I should get it in a few days. This one was made to order---a bit smaller,shorter table and much lighter than his latest model. I will let you know how it is when it arrives. Tricky Ricky |
KC Cameron Inner circle Raleigh, North Carolina 1944 Posts |
Edd,
After a couple spills because some dumb magician (myself) forgot to latch my case, I like how the handle is positioned. As for the plastic look, I agree, but I will have it covered anyway, so it isn't an issue. ~~~~ Thanks Tricky Ricky, I look forward to your review! |
wizardofsorts Special user Chicago, IL 935 Posts |
Capt. Kid,
I think we've all done that. I did it once in front of a country club. I lifted the table to take it down a few fronts steps to the ground. It flung open and everything, including an entire deck of cards fell onto the ground. Needless to say there was quite an audience! Edd
Edd Fairman, Wizard of Sorts is a corporate magician available for your next trade show, hospitality suite, client luncheon, or company event. http://www.wizardofsorts.com
|
TrickyRicky Inner circle TrickyRicky 1653 Posts |
Quote:
On 2008-02-01 11:33, wizardofsorts wrote: Hi Edd. One of the new feature on the Tony Clark's table, is the locking device that locks the top to the base once its open. You can actually pick up the entire open table and move it wherever you want. I should receive mine by Monday at least. I tracked the shipment by Fedex, and it;s at customs waiting clearance. Tricky Ricky |
shpf100 Regular user 146 Posts |
I'm interested in this and am awaiting your review of it Tricky Ricky. Besides what you think of the quality, value compared to the lefler and the old Tony Clark Table, I'm curious what the performing surface is-does it have a carpeted top or is it just plastic?
|
KC Cameron Inner circle Raleigh, North Carolina 1944 Posts |
The table sounds great - anything to keep me from looking stupid is a big plus! I have had kids lean on my table and bring it down several times too, so the lock sounds good. Waiting for your review Tricky Ricky! *S*
|
TrickyRicky Inner circle TrickyRicky 1653 Posts |
The case is very sturdy, and will hold quite a bit of props.
The only reservation I have is with the handle. The handle base could use more support, I don't think it a big problem, better safer than sorry. The table top section needs more support at the sides. I have someone who can install the supports, that wont be too much a problem I placed some metal plates (35 lbs) on the table without any buckling. With the locking device, the table can support a bit of weight, but you would have problems if someone should use his hands and press down hard. The case is the lightest one so far, about 17 to 18 lbs. I transferred my props from the other case to this one and it weigh less than the old empty case. Assembling the table with the locking pins was quite easy. You will be able to carry the table around without any fear that it will come apart. I was a bit disappointed with the height of the table, considering that I paid Tony an extra $100 to customize the table. I found the height to be the same as his old model that I'm presently using 37 inches. My request was for a height of 34 3/4. There are 2 shelves to put all the tricks needed for your performance and a large enough space at the bottom to store props. The casters installed was of the cheapest on the market. Maybe this was caused by my request to Tony not to install the casters since I was going to replace them with rubber ones. The black ABS material is very hard and should take quite a beating. You would need to install matting or speaker cover material on top. you could get away with using a large close--up pad. Just now 2 of my magic buddies stopped over to have a look at the table. I voiced my complaints to them about the need for reinforcement of the table top. They didn't think that anything need to be done at all. Maybe I'm a bit too fussy. I have the feeling that my table was the first one off the line. I will pass on improvements to Tony. His next one should be better than mine. If Tony will use the improvements for the next one, I would recommend it. I will use it in my show tomorrow and see how it holds up. Tricky Ricky |
KC Cameron Inner circle Raleigh, North Carolina 1944 Posts |
Hey Tricky Ricky, thanks for the honest answer! I was worried about the ABS cracking - do you think that is an issue?
|
Alan Munro Inner circle Kentwood, Michigan, USA 5952 Posts |
I had my fill of suitcase tables, many years ago. I'd rather make an extra trip than throw out my back. For kidshows, the props are in a plastic tote, about the size of a large footlocker. I can lift the thing easily, when empty, just by flexing my little finger. I decorated one end of it, so that it looks showy. It's brightly colored and rests on a tray stand. I don't have to duck behind a something to get at a prop - I just reach into the tote.
|
shpf100 Regular user 146 Posts |
Good question on the cracking, it's been at or below zero here for awhile and plastic typically can crack if it gets cold like that.
|
JamesinLA Inner circle Los Angeles 3400 Posts |
Hey, Richard, tell me more about the rubber wheels you were going to replace the casters with. I've built a couple suitcase tables and the casters I got from the hardware store are hard rubber/plastic and they make a godawful sound when going over any hard surface. I would love to find small soft rubber wheels that would be quiet. Have you found wheels like that? Thanks.
Jim
Oh, my friend we're older but no wiser, for in our hearts the dreams are still the same...
|
TrickyRicky Inner circle TrickyRicky 1653 Posts |
Hi Jim.
You are so right about those little black wheels. It's embarrassing to run those wheels on the pavement or side walks.It's sounds like a train crossing tracks. I gave the case to a friend who is quite handy with making cabinets. One of the many changes he's making to the case is replacing the wheels. The wheels are colored gray , larger and softer. Much less noise than the small black ones. Apparently, the rubber material gets harder in small amount. The ABS wont crack in the cold, it's very hardy and can stand up to lots of abuse. Tony's cases are the lightest on the market. The Lefler's rolons are quite good, but just too heavy for my bad shoulders. It's a case of what suits you best. Tony is looking into making them with thicker colored ABS. Richard. |
KC Cameron Inner circle Raleigh, North Carolina 1944 Posts |
If Tony is reading this, it would be nice if it had "wings" to act as additional "table top" like this DJ case. They could come off and be stored inside the case.
http://www.activemusician.com/item--MC.SKB1818 |
socalmagic Loyal user Los Angeles 267 Posts |
JamesinLA,
Linco Caster (http://lincocasters.com/casters.htm) in South El Monte has a phenomenal selection of high quality casters. I've replaced nearly every caster on my supposed high end illusions that came with cheap casters. They have one in particular that is $17.50 each, but has a really nice look to it with an easy to use break, and it's weight capacity is ridiculous. Brock Edwards |
JamesinLA Inner circle Los Angeles 3400 Posts |
Thanks, Brock, I will check it out. Is it soft rubber so it won't make that godawful racket?
Jim
Oh, my friend we're older but no wiser, for in our hearts the dreams are still the same...
|
socalmagic Loyal user Los Angeles 267 Posts |
Yes, they have all types of casters, and most of the are the soft rubber.
|
KidMagic Regular user Bradford 183 Posts |
I agree with wizardofsorts, I would definatly cover it with something more inviting to the children! LOL
Zach |
alexa Veteran user NJ 393 Posts |
I am wondering if you've spoken with Tony and if he's said he will make those changes as you said?
Alexa |
The Magic Cafe Forum Index » » The little darlings » » Tony Clark's - Ultra Lite Suitcase Table (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.04 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |