|
|
Go to page [Previous] 1~2 | ||||||||||
remote guy Special user Maryland 534 Posts |
If you review the diagram, you will need an on/off switch as well as a battery connector. I used the extra long wires form the battery snap, and the servo wires were shortened. If you are not going to shorten the wires, then you will need wire as well.
Then you will need a way to connect the servo and board to the a case or wood board. Remember, don't short out the components the board. [/quote] The relay on the R/C receiver will act as a switch. You should be able to power the servo controller with the same 9 volt battery that powers your R/C receiver. Nick |
|||||||||
PWB New user 71 Posts |
Check out Blue Point Engineering (303) 651-3794, it is not too difficut to get a small servo controller and link it to a simple one or two channel reciever. any questions let me know
PWB |
|||||||||
Bill Hegbli Eternal Order Fort Wayne, Indiana 22797 Posts |
Okay, I did some Google-ing and found you are talking about a "Servo controller board", not just any board that control a servo. Isn't the English language as puzzling as Electronics.
|
|||||||||
TheRaven Special user 597 Posts |
Remote Guy - Thanks for posting that controller. I've searched but never been able to find something like that.
|
|||||||||
Lou Hilario Inner circle 2235 Posts |
Finally got my one channel remote and dual servo controller. Thanks to remote guy for sharing this. Unfortunately, this will not work with the mask I am making because of its size and it will be hard to control the mouth opening with the correct movements to the words. But I will try attaching this to a mask and see.
Thanks again Nick! Here is a video of the components and operation. I just used two 9V batteries because it was easier to hook up, but definitely one 9V battery will work. http://www.youtube.com/watch?v=mNuNdrptIuc
Magic, Illusions, Juggling, Puppet & Parrot Show ^0^
http://www.louhilario.net |
|||||||||
The Magic Cafe Forum Index » » The workshop » » I need a small remote to control a servo. (0 Likes) | ||||||||||
Go to page [Previous] 1~2 |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |