|
|
Go to page [Previous] 1~2 | ||||||||||
Dynamike Eternal Order FullTimer 24148 Posts |
How do you guys carry the mailbox around? Do you have a custom made transportation case for it? Presently I am carrying it around openly. I am afraid damage can happen to the flag.
|
|||||||||
Bill Hegbli Eternal Order Fort Wayne, Indiana 22797 Posts |
Mike, something that big needs is own case, to protect is and transportation.
Take a look at some good Foot Lockers to see if it will fit all the props in, if so, then make custom partitions. They sell foot lockers that have 2 wheels on one end. Just like your Flower act, everything needs cases. |
|||||||||
Dynamike Eternal Order FullTimer 24148 Posts |
|
|||||||||
Dave Scribner Assistant Manager Lake Hopatcong, NJ 4849 Posts |
Hey Mike, if you go to home depot or somewhere that sells mailboxes, you can find cheap ones in a variety of sizes. They run about $15 for a standard size but there are larger ones available. The boxes are pretty sturdy and if you want, you could always line the sides of the box with foam or something similar.
Where the magic begins
|
|||||||||
Dynamike Eternal Order FullTimer 24148 Posts |
Quote:
On Mar 6, 2016, Bill Hegbli wrote: Thanks I found one. But the tripod will not fit inside. I am going to make a pouch made of vinyl that can hold the tripod. Next velcro it to the outside of the case. Quote:
On Feb 5, 2016, Dynamike wrote: Here is picture of the connector I was talking about previously: Disconnected: Connected: I do not like how all the wires are visible to the kids from a certain angle. I will put some thin wood or fabric over the opening to cover it up. |
|||||||||
Bill Hegbli Eternal Order Fort Wayne, Indiana 22797 Posts |
Mike, I suggest you get as sheet of aluminum at the hardware store and a heating and air condition vent bending tool and just make a box to fit over the electronics. Just use Velcro to attach. You don't was a tight seal, as electronics needs to be vented against heat build up.
You can make that table base fit, but cutting the tubes down. I got the same stand from Steven's Magic and cut 2" off each pipe, because I did not want it any higher then 32". Looks like you would only need to cut an inch or so off, to make it fit in the case. Is there enough room to put in diagonally and put a piece of foam over it? |
|||||||||
The Magic Cafe Forum Index » » Polly wants a cracker... » » Hare Mail Mailbox (0 Likes) | ||||||||||
Go to page [Previous] 1~2 |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.02 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |