|
|
mip New user 60 Posts |
I always have trouble getting the folded bill out of the TT. The bill "opens" a little when inside and press against the inside which makes it hard to grip.
Suggestions? |
Magix Elite user 432 Posts |
If you're talking about a simple vanish with no specific folding required, I ask the spectator to sign it, or tear off a corner and then roll it into a small tube. I then ask them to flatten it for me "so it doesn't unroll".
Then when they hand it over I can either fold it in half in front of them, or fold it in half as I load it. It then forms a V shape when its loaded and my thumb goes in the middle of the V. Usually makes for easy gripping. Hope this helps........ |
Kaliix Inner circle Connecticut 1984 Posts |
I had the same problem. My solution was to carefully put a piece (or two) of good ole scotch tape on the inside of the TT, where the bill would stick.
Now I don't have a problem. Give it a try.
The greatest obstacle to discovery is not ignorance; it is the illusion of knowledge.
~Daniel J. Boorstin |
Allan Elite user 405 Posts |
I think the problem you are describing is that the folded layers separate not leaving room for your thumb to enter the tt. If that is your problem, take the edge of the folded bill closest to the TT& make a soft fold with the last 1/3 of the bill. this will hold all the layers together & make sure that there is room for your thumb to enter the tt
|
The Magic Cafe Forum Index » » Nothing up my sleeve... » » Money in TT (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |