|
|
MarkTirone Inner circle palming not 1 coin, but 1139 Posts |
Ok. So I decided that I wanted to make my small blob of silver out of solder. I was planning on just making it by melting it by dripping it onto the floor and kind of stirring it around a little to make it so that it looks like a little chunk, then when it dries, melting the flat side a little bit. Another thing I wanted to make was a copper coin with solder on one side of it, to look like you melt down a silver coin a little bit to reveal the copper inside. What I wanted to ask is, on the package for the solder, it says it won't adhere to any surface that has not been "fluxed". Should I buy "flux" even if I don't want it to stick and will it stick together and to a coin or will it just stick together and dry together (the solder)
|
Eldon Inner circle Virden, IL 1137 Posts |
You won't need flux for your small blob. If you take some sand-paper or emery-cloth and clean and rough-up your coin it should take the solder without flux. Just give it a try. Your not going to hurt anything. If the solder doesn't stick to the coin, sand it again and use some flux.
|
remote guy Special user Maryland 534 Posts |
You say you want to melt the solder and let it drip on the floor where you plan on stirring it around a bit. You will not be able to stir the solder, as soon as it hits the floor it will solidify. You do not need flux if you just want to make a blob on the floor.
Nick |
The Magic Cafe Forum Index » » The workshop » » Solder (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |