|
|
Mattia Regular user 128 Posts |
Hello,
I'm planning to build a mini 3 cube zig-zag. What should be the thickness of the wood used to build it? Thanks, Mattia |
briansmagic Special user USA 507 Posts |
I'd probably go w/ half inch ply. My Chalet Kub is 3/8" I believe...but since the illusion you're talking about is a bit bigger, I think half would be the way to go.
|
MagicB1S Inner circle Knoxville Tenn. 1039 Posts |
1/2 inch will be just fine with 3/4 inch base, Might be a little heavy but built to last
"There are Tricks To All Trades.... My Trade is all Tricks"
"An amature practices until he gets it right. A Professional Practices until he can't get it wrong" www.Themagicchest.webs.com bobswislosky@yahoo.com |
The Magic Cafe Forum Index » » The workshop » » Mini 3 cube zag (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |