|
|
brody Inner circle Omaha 1313 Posts |
|
Michael Baker Eternal Order Near a river in the Midwest 11172 Posts |
I recall there was an involved thread a couple years ago about similar DIY powder coating kits. Seemed sort of practical for small hobbyist jobs.
~michael baker
The Magic Company |
MentalistCreationLab Inner circle 1528 Posts |
Here is a trick when powder coating any metal, clean the metal with kerosene then do not touch it with bare hands or the finger prints will cause flash rust under the coating. Learned that the hard way after touching about 200 feet of ornamental fence I built years ago.
|
The Magic Cafe Forum Index » » The workshop » » Powder coating from MAKE magazine (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |