We Remember The Magic Café We Remember
[ Lost Password ]
  [ Forgot Username ]
The Magic Cafe Forum Index » » The workshop » » Metal worker needed for simple part (0 Likes) Printer Friendly Version

View Profile
Inner circle
2209 Posts

Profile of jprace
Hello -

I am looking for quite a simple piece:

A thin [flat] piece of metal in the shape of a rectangle (2.5cm x 4.5cm) that is attracted to a magnet.

If you're able to help, I'd be very appreciative. Please PM me if you can for more details!


Phone Phreak is here!
Watch the Trailer!
Catch me on Instagram
View Profile
Inner circle
East Orange, NJ
3211 Posts

Profile of jimgerrish
Olive oil can and tin snips.
jay leslie
View Profile
Southern California
9495 Posts

Profile of jay leslie
Ed Massey used to bring Jim Swoger his prototypes made from tin cans. Of course, that was during the war so metal was scarce.

Go to a sheet metal shop. That's the least expensive way if you can't make it yourself.
View Profile
Special user
632 Posts

Profile of Bill08
If you can get to a hobby shop you might find a piece that is thin enough to cut with a good pair of scissors.
View Profile
Inner circle
7378 Posts

Profile of hugmagic
I mailed the metal pieces to you yesterday to play with.
Richard E. Hughes, Hughes Magic Inc., 352 N. Prospect St., Ravenna, OH 44266 (330)296-4023
Write direct as I will be turning off my PM's.
The Magic Cafe Forum Index » » The workshop » » Metal worker needed for simple part (0 Likes)
[ Top of Page ]
All content & postings Copyright © 2001-2020 Steve Brooks. All Rights Reserved.
This page was created in 0.13 seconds requiring 5 database queries.
The views and comments expressed on The Magic Café
are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic.
> Privacy Statement <

ROTFL Billions and billions served! ROTFL