|
|
misamagic![]() New user 49 Posts ![]() |
Hi
I am interested, in a trick, to cut the mem deck so that a certain card/stack number is at the bottom of the deck. Is it ok to replace estimation, cut, peek, undercut by spreading the deck face up and finding and eliminating the jokers and in this process cutting the deck at the right place? Are there any books/dvds on this? Thank you Best regards Mihail |
Waterloophai![]() Inner circle Belgium 1276 Posts ![]() |
|
Bobby Forbes![]() Inner circle virginia beach, VA. 1539 Posts ![]() |
+1 for Http://maigret.org/csystem/
|
misamagic![]() New user 49 Posts ![]() |
Thank you very much.
i also found a move by allan ackerman: ultimate gesture cut. I trust it can be used to cut a deck to a certain place. best regards mihail |
JanForster![]() Inner circle Germany ... when not traveling... 3911 Posts ![]() |
There are several ways to proceed... I normally prefer to cut the face down deck and proceed (like Simon Aronson describes it very well) by “cut, glimpse and adjust”. It should just look like toying with the cards. Generally it is easier to cut a bit less than you need as the adjusting is easier if you have to cut additionally a card/some cards from top to bottom than cutting from bottom to top. Jan
Jan Forster
www.janforster.de |
Rhu![]() New user 22 Posts ![]() |
+2 for Http://maigret.org/csystem/
|
The Magic Cafe Forum Index » » Shuffled not Stirred » » Technical question (3 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2021 Steve Brooks. All Rights Reserved. This page was created in 0.16 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < ![]() ![]() ![]() |